ZyXEL Communications nbg-418n User Manual
Chapter 3 Connection Wizard
NBG-418N User’s Guide
24
Figure 10
Wizard Step 2: Wireless LAN
The following table describes the labels in this screen.
Note: The wireless stations and NBG-418N must use the same SSID, channel ID, WPA-
PSK (if WPA-PSK is enabled) or WPA2-PSK (if WPA2-PSK is enabled) for wireless
communication.
3.3.1 WPA-PSK or WPA2-PSK Security
Choose WPA-PSK or WPA2-PSK security in the Wireless LAN setup screen to set up a Pre-
Shared Key.
Shared Key.
Table 4
Wizard Step 2: Wireless LAN
LABEL
DESCRIPTION
Name (SSID)
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN.
If you change this field on the NBG-418N, make sure all wireless stations use the same
SSID in order to access the network.
SSID in order to access the network.
Security
Select a Security level from the drop-down list box.
Choose None to have no wireless LAN security configured. If you do not enable any wireless
security on your NBG-418N, your network is accessible to any wireless networking device
that is within range. If you choose this option, skip directly to
security on your NBG-418N, your network is accessible to any wireless networking device
that is within range. If you choose this option, skip directly to
.
Choose WPA-PSK or WPA2-PSK security to configure a Pre-Shared Key. Choose this
option only if your wireless clients support WPA-PSK or WPA2-PSK respectively. If you
choose this option, skip directly to
option only if your wireless clients support WPA-PSK or WPA2-PSK respectively. If you
choose this option, skip directly to
Channel
Selection
Selection
The range of radio frequencies used by IEEE 802.11b/g/n wireless devices is called a
channel.
channel.
Set the operating frequency/channel depending on your particular region. Select a channel
from the drop-down list box. The options vary depending on the frequency band and the
country you are in.
from the drop-down list box. The options vary depending on the frequency band and the
country you are in.
This option is only available if Auto Channel Selection is disabled.
Auto Channel
Selection
Selection
Select this option for the NBG-418N to automatically choose the channel with the least
interference. Deselect this option if you wish to manually select the channel using the
Channel Selection field.
interference. Deselect this option if you wish to manually select the channel using the
Channel Selection field.
Back
Click Back to display the previous screen.
Next
Click Next to proceed to the next screen.
Exit
Click Exit to close the wizard screen without saving.