ZyXEL Communications P-793H User Manual

Chapter 5 WAN Setup

P-793H User’s Guide

Figure 26   WAN > Internet Connection

The following table describes the labels in this screen. 

Table 15   WAN > Internet Connection

General

Name

Enter the name of your Internet Service Provider, for example “MyISP”. This 

information is for descriptive purposes only.

Mode

Select Routing (default) from the drop-down list box if your ISP allows multiple 

computers to share an Internet account. Otherwise select Bridge. 

Encapsulation

Select the method of encapsulation used by your ISP from the drop-down list 

box. Choices vary depending on the mode you select in the Mode field. 
If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET 

ENCAP or PPPoE.
If you set up a point-to-point or a point-to-2points connection, select either ENET 

ENCAP or RFC 1483.

User Name

(PPPoA and PPPoE only) Enter the user name exactly as your ISP assigned. If 

assigned a name in the form user@domain where domain identifies a service 

name, then enter both components exactly as given.