ZyXEL Communications P-793H User Manual

Chapter 5 WAN Setup

P-793H User’s Guide

The Service Mode section of the Internet Connection screen allows you to set up two DSL 
connections when you select 2wire-2line mode. This allows you to create a point-to-2points 
configuration. See 

 for more background information about this mode.

Figure 27   2wire-2line Service Mode

Enable Rate 

Adaption

This field is enabled if Service Type is Server. Indicate whether or not the 

ZyXEL Device can adjust the speed of its connection to that of the other device.

Transfer Max Rate 

(Kbps)

This field is enabled if Service Type is Server. Set the maximum rate at which 

the ZyXEL Device sends and receives information. The actual transfer rate will 

be between this value and the minimum transfer rate you configure.    

Note: When you select 4-wire in the Service Mode field, then the 

transfer rate you set here is doubled. For example, select 
5696 Kbps to configure a maximum transfer rate of 11392 
Kbps.  

Transfer Min Rate 

(Kbps)

This field is enabled if Service Type is Server. Set the minimum rate at which 

the ZyXEL Device sends and receives information. The actual transfer rate will 

be between this value and the maximum transfer rate you configure. 

Note: When you select 4-wire in the Service Mode field, then the 

transfer rate you set here is doubled. For example, select 
192 Kbps to configure a minimum transfer rate of 384 
Kbps.  

Standard Mode

This field is enabled if Service Type is Server. Select the operational mode the 

ZyXEL Device uses in the DSL connection. Annex A refers to connections over 

POTS and Annex B refers to connections over ISDN lines.

Apply

Click Apply to save the changes. 

Cancel

Click Cancel to begin configuring this screen afresh.

Advanced Setup

Click this button to display the Advanced WAN Setup screen and edit more 

details of your WAN setup.

Table 15   WAN > Internet Connection (continued)