ZyXEL Communications NWA3000-N User Manual

Chapter 10 Device HA

NWA3000-N Series User’s Guide

This screen lets you enable or disable monitoring of an interface and set the 
interface’s management IP address and subnet mask. To access this screen, click 
Configuration > Device HA > Active-Passive Mode > Edit.

Figure 59   Device HA > Active-Passive Mode > Edit Monitored Interface  

Password

Enter the password used for verification during synchronization. Every 
NWA3000-N series AP in the virtual router must use the same 
password. 

If you leave this field blank in the master NWA3000-N series AP, no 
backup NWA3000-N series APs can synchronize from it. 

If you leave this field blank in a backup NWA3000-N series AP, it cannot 
synchronize from the master NWA3000-N series AP. 

Auto 
Synchronize

Select this to get the updated configuration automatically from the 
specified NWA3000-N series AP according to the specified Interval. 
The first synchronization begins after the specified Interval; the 
NWA3000-N series AP does not synchronize immediately.

Interval

When you select Auto Synchronize, set how often the NWA3000-N 
series AP synchronizes with the master. 

Apply

This appears when the NWA3000-N series AP is currently using active-
passive mode device HA.  Click Apply to save your changes back to the 
NWA3000-N series AP.

Reset

Click Reset to return the screen to its last-saved settings. 

Table 45   Configuration > Device HA > Active-Passive Mode (continued)