ZyXEL Communications G-3000H User Manual

G-3000H User’s Guide

Chapter 17 LAN Setup

189

Figure 118 Menu 3.5.4 Bridge Link Configuration

The following table describes the fields in this menu.

17.3.5 Configuring Layer-2 Isolation

Follow the steps below to configure layer-2 isolation on your ZyAIR.

1 From the main menu, enter 3 to open Menu 3 – LAN Setup.

2 Enter 5 to display Menu 3.5 – Wireless LAN Setup.

Menu 3.5.4 - Bridge Link Configuration

   Enable Link 1= Yes      Peer MAC Address= 0b:16:21:2c:37:45
   PSK= ********
Enable Link 2= No Peer MAC Address= 00:0b:16:2c:37:3d
   PSK= ********
   Enable Link 3= Yes      Peer MAC Address= 0b:16:21:2c:37:3e
   PSK= ********
Enable Link 4= No Peer MAC Address= 0b:16:21:2c:37:3f
   PSK= ********
   Enable Link 5= Yes      Peer MAC Address= 0b:16:21:2c:37:40
   PSK= ********

Enable WDS Security= Yes

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Table 68 Menu 3.5.4 Bridge Link Configuration

FIELD

DESCRIPTION

Enable Link 1 ~ 5

Press [SPACE BAR] to select Yes or No and press [ENTER].

Peer MAC Address

Type the MAC address of peer device in valid MAC address format, that is, six

hexadecimal character pairs, for example, 12:34:56:78:9a:bc.

PSK

Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including

spaces and symbols)

Enable WDS Security Select Yes to enable WDS on your ZyAIR. A Wireless Distribution System

(WDS) is a wireless connection between two or more APs.
When you select Yes, you are prompted to type a Pre-Shared Key (PSK) in the

PSK fields of each bridge link you want to configure. The ZyAIR uses TKIP to

encrypt traffic on the WDS between AP’s.

Note: Other AP’s must use the same encryption method to
enable WDS.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.