ZyXEL Communications NBG6503 User Manual
Chapter 8 Access Point Mode
NBG6503 User’s Guide
66
8.3.1 Setting your Router to AP Mode
1
Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on
how to do this.
how to do this.
2
To use your Router as an access point, go to Maintenance > Sys OP Mode and select Access
Point mode.
Point mode.
Figure 44 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon
as you do, your Router is already in Access Point mode.
3
When you select Access Point Mode, the following pop-up message window appears.
Figure 45 Pop up for Access Point mode
Click OK.
4
Click Apply. The Web Configurator refreshes once the change to Access Point mode is successful.
8.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1
Connect your computer to the LAN port of the Router.
2
The default IP address of the Router is “192.168.1.2”. In this case, your computer must have an IP
address in the range between “192.168.1.3” and “192.168.1.254”.
address in the range between “192.168.1.3” and “192.168.1.254”.