ZyXEL Communications 650HW User Manual

Prestige 650HW ADSL Router User’s Guide 

3-10 

Internet Access 

Primary DNS Server 

Secondary DNS Server 

Enter the IP addresses of the DNS servers.  The DNS servers are 
passed to the DHCP clients along with the IP address and the 
subnet mask. 

 

Remote DHCP Server If Relay is selected in the DHCP field above then enter the IP 

address of the actual remote DHCP server here. 

 

Follow the instructions in the following table to configure TCP/IP parameters for the Ethernet port. 

TCP/IP Setup 

 

 

IP Address Enter the (LAN) IP address of your Prestige in dotted decimal 

notation 

192.168.1.1  

IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on 

the IP address that you assign.  Unless you are implementing 
subnetting, use the subnet mask computed by the Prestige. 

255.255.255.0 

 

RIP Direction Press [

SPACE BAR

] to select the RIP direction.  Choices are 

Both, In Only, Out Only or None. 

Both  

(default) 

Version Press [

SPACE BAR]

 to select the RIP version.  Choices are RIP-1, 

RIP-2B or RIP-2M. 

RIP-1  

(default) 

Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol 

used to establish membership in a Multicast group. The Prestige 
supports both IGMP version 1 (IGMP-v1) and version 2 ( IGMP-v2). 
Press the [

SPACE BAR]

 to enable IP Multicasting or select None 

to disable it. 

(default) 

IP Policies Create policies using SMT menu 25 (see the IP Policy Routing 

chapter) and apply them on the Prestige LAN interface here.  You 
can apply up to four IP Policy sets (from twelve) by entering their 
numbers separated by commas. 

2,4,7,9 

Edit IP Alias The Prestige supports three logical LAN interfaces via its single 

physical Ethernet interface with the Prestige itself as the gateway for 
each LAN network. Press [

SPACE BAR

] to change No to Yes and 

press [

ENTER

] to for menu 3.2.1 

No  

(default)