ZyXEL Communications AMG1302 User Manual

 Chapter 7 Wireless LAN

AMG1302/AMG1202-TSeries User’s Guide

Use this screen to configure WiFi Protected Setup (WPS) on your AMG1302/AMG1202-TSeries.

WPS allows you to quickly set up a wireless network with strong security, without having to 
configure security settings manually. Set up each WPS connection between two devices. Both 
devices must support WPS. See 

 for more information about WPS.

Note: The AMG1302/AMG1202-TSeries applies the security settings configured in the 

General screen (see 

). If you want to use the WPS feature, 

make sure you have set the security mode to WPA2-PSK or No Security.

Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click 
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.

Add new MAC 
address

Click this if you want to add a new MAC address entry to the MAC filter list below.

Enter the MAC addresses of the wireless devices that are allowed or denied access to the 
AMG1302/AMG1202-TSeries in these address fields. Enter the MAC addresses in a valid MAC 
address format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.

#

This is the index number of the entry.

MAC Address

This is the MAC addresses of the wireless devices that are allowed or denied access to the 
AMG1302/AMG1202-TSeries.

Modify

Click the Delete icon to delete the entry.

Apply

Click Apply to save your changes.

Cancel

Click Cancel to exit this screen without saving.

Network Setting > Wireless > MAC Authentication (continued)