ZyXEL Communications 782M User Manual
P782M G.SHDSL Bridge
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
4.1.4 Editing PPP Options
To edit the remote node PPP options, move the cursor to the Edit PPP Options field in Menu 11.1 —
Remote Node Profile, use [SPACE BAR] to select Yes and then press [ENTER] to open menu 11.2, as
shown next.
Remote Node Profile, use [SPACE BAR] to select Yes and then press [ENTER] to open menu 11.2, as
shown next.
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Figure 4-3 Menu 11.2 — Remote Node PPP Options
The following table describes the menu 11.2 and how to configure the PPP options.
Table 4-2 Remote Node PPP Options Menu Fields
FIELD
DESCRIPTION
OPTIONS
Standard PPP
Encapsulation
Select Standard PPP. Select CISCO PPP only if
the node is a Cisco computer.
the node is a Cisco computer.
CISCO PPP
Compression
Turn on/off Stac Compression. The default is No.
Yes/No
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC] to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.2 Remote
Node
Setup
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 — Remote Node Network
Layer Options as shown next.
Layer Options as shown next.
Remote Node Configuration
4-5