ZyXEL Communications P-660HN-F1 User Manual
Chapter 7 Wireless LAN
P-660HN-F1 User’s Guide
107
7.2 The AP Screen
Use this screen to configure the wireless settings of your ZyXEL Device. Click Network >
Wireless LAN to open the AP screen.
Wireless LAN to open the AP screen.
Figure 48 Network > Wireless LAN > AP
The following table describes the labels in this screen.
Table 28 Network > Wireless LAN > AP
LABEL
DESCRIPTION
Wireless Setup
Active Wireless
LAN
LAN
Click the check box to activate wireless LAN.
Auto-Scan
Channel
Channel
Select this option for the ZyXEL Device to automatically choose a channel with least
interference. Do not select this check box if you want to manually select a channel
using the Channel Selection field.
interference. Do not select this check box if you want to manually select a channel
using the Channel Selection field.
Channel
Selection
Selection
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
Select a channel from the drop-down list box.
Channel Width
Select whether the ZyXEL Device uses a wireless channel width of 20 or 40 MHz. A
standard 20 MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz
channel uses two standard channels and offers speeds of up to 300 Mbps. Because
not all devices support 40 MHz channels, select Auto 20/40MHz to allow the ZyXEL
Device to adjust the channel bandwidth automatically.
standard 20 MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz
channel uses two standard channels and offers speeds of up to 300 Mbps. Because
not all devices support 40 MHz channels, select Auto 20/40MHz to allow the ZyXEL
Device to adjust the channel bandwidth automatically.