ZyXEL Communications P-660HN-F1 User Manual

Chapter 4 Internet and Wireless Setup Wizard

P-660HN-F1 User’s Guide

Figure 16   Internet Access Wizard Setup: ISP Parameters

The following table describes the fields in this screen.

Table 8   Internet Access Wizard Setup: ISP Parameters

Mode

Select Routing (default) from the drop-down list box if your ISP give you one IP 
address only and you want multiple computers to share an Internet account. Select 
Bridge when your ISP provides you more than one IP address and you want the 
connected computers to get individual IP address from ISP’s DHCP server directly. If 
you select Bridge, you cannot use Firewall, DHCP server and NAT on the ZyXEL 
Device.

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list 
box. Choices vary depending on what you select in the Mode field.  
If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or 
PPPoE.

Multiplexing

Select the multiplexing method used by your ISP from the Multiplex drop-down list 
box either VC-based or LLC-based. 

Virtual Circuit 
ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. 
Refer to the appendix for more information.

VPI

Enter the VPI assigned to you. This field may already be configured.

VCI

Enter the VCI assigned to you. This field may already be configured.

Back

Click this to return to the previous screen without saving.

Next

Click this to continue to the next wizard screen. The next wizard screen you see 
depends on what protocol you chose above. 

Exit

Click this to close the wizard screen without saving.