ZyXEL Communications P-2302R Series User Manual
P-2302R Series User’s Guide
Chapter 26 Remote Node Configuration
252
26.4 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to
set the value to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
set the value to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between
this remote node and the Prestige to prevent certain packets from triggering calls. You can
specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. For PPPoE encapsulation, you have the additional
option of specifying remote node call filter sets.
this remote node and the Prestige to prevent certain packets from triggering calls. You can
specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. For PPPoE encapsulation, you have the additional
option of specifying remote node call filter sets.
Private
This field is valid only for PPPoE encapsulation. This parameter determines if the
Prestige will include the route to this remote node in its RIP broadcasts. If set to Yes,
this route is kept private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP broadcasts.
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP direction from Both/ None/
In Only/Out Only. The default for RIP on the WAN side is None. It is recommended
that you do not change this setting.
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-1/RIP-2B/
RIP-2M or None.
Multicast
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a Multicast group. The Prestige supports both IGMP version
1 (IGMP-v1) and version 2 (IGMP-v2). Press [SPACE BAR] to enable IP Multicasting
or select None to disable it. See
for more information on this
feature.
Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER]
at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or press
[ESC] at any time to cancel.
Table 106 Remote Node Network Layer Options (continued)
FIELD
DESCRIPTION