ZyXEL Communications MES3500-24 User Manual

Chapter 44 Configure Clone

MES3500-24/24F User’s Guide

The following table describes the labels in this screen. 

Management > Configure Clone 

Source/
Destination

Port

Enter the source port under the Source label. This port’s attributes are copied.

Enter the destination port or ports under the Destination label. These are the ports which 
are going to have the same attributes as the source port. You can enter individual ports 
separated by a comma or a range of ports by using a dash.

Example: 

•

2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports. 

•

2-6 indicates that ports 2 through 6 are the destination ports.

Basic Setting

Select which port settings (you configured in the Basic Setting menus) should be copied to 
the destination port(s). 

Advanced 
Application

Select which port settings (you configured in the Advanced Application menus) should be 
copied to the destination ports. 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these 
changes if it is turned off or loses power, so use the Save link on the top navigation panel to 
save your changes to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.