ZyXEL Communications ZyWALL 1000 User Manual

Chapter 44 Service Control

ZyWALL USG 1000 User’s Guide

Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or SNMP 
screen to add a service control rule. 

Figure 429   System > Service Control Rule Edit   

The following table describes the labels in this screen.  

If you haven’t changed the default HTTPS port on the ZyWALL, then in your browser enter 
“https://ZyWALL IP Address/” as the web site address where “ZyWALL IP Address” is the IP 
address or domain name of the ZyWALL you wish to access.

Client 

Authentication 

Method

Select a method the HTTPS or HTTP server uses to authenticate a client.
You must have configured the authentication methods in the Auth. method screen.

Apply

Click Apply to save your changes back to the ZyWALL. 

Reset

Click Reset to begin configuring this screen afresh.

Table 206   System > WWW (continued)

Table 207   Edit Service Control Rule

Address Object

Select ALL to allow or deny any computer to communicate with the ZyWALL using 

this service.
Select a predefined address object to just allow or deny the computer with the IP 

address that you specified to access the ZyWALL using this service.

Zone

Select ALL to allow or prevent any ZyWALL zones from being accessed using this 

service.
Select a predefined ZyWALL zone on which a incoming service is allowed or 

denied.

Action

Select Accept to allow the user to access the ZyWALL from the specified 

computers.
Select Deny to block the user’s access to the ZyWALL from the specified 

computers.

OK

Click OK to save your customized settings and exit this screen. 

Cancel

Click Cancel to exit this screen without saving