ZyXEL Communications 5 Series User Manual
Chapter 37 LAN Setup
ZyWALL 5/35/70 Series User’s Guide
637
Use the instructions in the following table to configure IP alias parameters.
Table 226 Menu 3.2.1: IP Alias Setup
FIELD
DESCRIPTION
IP Alias 1, 2
Choose Yes to configure the LAN network for the ZyWALL.
IP Address
Enter the IP address of your ZyWALL in dotted decimal notation.
IP Subnet Mask
Your ZyWALL will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the ZyWALL.
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the ZyWALL.
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are
Both, In Only, Out Only or None.
Both, In Only, Out Only or None.
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are
RIP-1, RIP-2B or RIP-2M.
RIP-1, RIP-2B or RIP-2M.
Incoming
Protocol Filters
Protocol Filters
Enter the filter set(s) you wish to apply to the incoming traffic between this node and
the ZyWALL.
the ZyWALL.
Outgoing
Protocol Filters
Protocol Filters
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the ZyWALL.
the ZyWALL.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to
save your configuration, or press [ESC] at any time to cancel.
save your configuration, or press [ESC] at any time to cancel.