ZyXEL Communications 100 Series User Manual

 Chapter 4 Wizard Setup

ZyWALL USG 100/200 Series User’s Guide

Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same 
password. Use 8 to 31 case-sensitive ASCII characters or 16 to 62 hexadecimal (“0-9”, “A-F”) 
characters. Proceed hexadecimal characters with “0x”.

Figure 36   VPN Express Wizard: Step 3

The following table describes the labels in this screen.

The Policy Setting specifies which devices can use the VPN tunnel. Local and remote IP 
addresses must be static. 

Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also 
specify a subnet. This must match the remote IP address configured on the peer IPSec device. 

Remote Policy (IP/Mask): Type the IP address of a computer behind the peer IPSec device. 
You can also specify a subnet. This must match the local IP address configured on the peer 
IPSec device.

Table 16   VPN Express Wizard: Step 3

Local Policy 
(IP/Mask)

Type a static local IP address that corresponds to the remote IPSec router's 
configured remote IP address (the remote IP address of the other ZyWALL). 
To specify IP addresses on a network by their subnet mask, type the subnet mask of 
the LAN behind your ZyWALL.

Remote Policy 
(IP/Mask)

Type a static local IP address that corresponds to the remote IPSec router's 
configured local IP address (the local IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of 
the LAN behind the remote gateway.

Next

Click Next to continue.