ZyXEL Communications 100 Series 사용자 설명서
Chapter 4 Wizard Setup
ZyWALL USG 100/200 Series User’s Guide
97
Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same
password. Use 8 to 31 case-sensitive ASCII characters or 16 to 62 hexadecimal (“0-9”, “A-F”)
characters. Proceed hexadecimal characters with “0x”.
password. Use 8 to 31 case-sensitive ASCII characters or 16 to 62 hexadecimal (“0-9”, “A-F”)
characters. Proceed hexadecimal characters with “0x”.
Figure 36 VPN Express Wizard: Step 3
The following table describes the labels in this screen.
4.8.1 VPN Express Wizard - Policy Setting
The Policy Setting specifies which devices can use the VPN tunnel. Local and remote IP
addresses must be static.
addresses must be static.
Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also
specify a subnet. This must match the remote IP address configured on the peer IPSec device.
specify a subnet. This must match the remote IP address configured on the peer IPSec device.
Remote Policy (IP/Mask): Type the IP address of a computer behind the peer IPSec device.
You can also specify a subnet. This must match the local IP address configured on the peer
IPSec device.
You can also specify a subnet. This must match the local IP address configured on the peer
IPSec device.
Table 16 VPN Express Wizard: Step 3
LABEL
DESCRIPTION
Local Policy
(IP/Mask)
(IP/Mask)
Type a static local IP address that corresponds to the remote IPSec router's
configured remote IP address (the remote IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind your ZyWALL.
configured remote IP address (the remote IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind your ZyWALL.
Remote Policy
(IP/Mask)
(IP/Mask)
Type a static local IP address that corresponds to the remote IPSec router's
configured local IP address (the local IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind the remote gateway.
configured local IP address (the local IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind the remote gateway.
Next
Click Next to continue.