Technicolor - Thomson 605 User Manual

Expert Configuration

E-DOC-CTC-20050429-0104 v1.0

5.2.5 Syslog

Overview

The Syslog page consists of two sections:

Messages

This section allows to overview system log and alert messages your SpeedTouch™ 
generated during operation. System log messages are used to provide a historical 
overview of events, errors, and messages generated during SpeedTouch™ operation.
Per message following information is shown:

The system message content (and time of generation)

By default the table is automatically refreshed every 30 seconds and shows all 
system log messages.

Click Stop AutoRefresh to stop the automatic refreshing of the table.
The Message buffer view options menu becomes accessible to:

Select the 

 level of syslog messages to show in the table.

Select the 

 level of syslog messages to show in the table.

Change the Refresh rate of the table.

As long as AutoRefresh is disabled you can manually refresh the table by 
clicking Refresh.

Click AutoRefresh to apply your changes and to start automatic update of the 
table (using the new refresh rate).

Configuration

This section allows you to view/configure remote destinations (syslog servers) to 
send (a subset of) the SpeedTouch™ syslog messages for remote monitoring 
purposes.
To add a destination:

In the Facility box, type the 

 of your choice.

In the Severity box, click the 

 of your choice.

In the Destination box, type a destination (IP address or host name) to send 
the messages to.

Click Add.