Technicolor - Thomson 605 User Manual

Troubleshooting

E-DOC-CTC-20050429-0104 v1.0

8.3 Reset to Factory Defaults

Resetting your

SpeedTouch™

You might consider a reset to factory defaults as described below.

You can choose between:

A reset to factory default settings deletes the configuration profile settings. 
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Also your WLAN clients will have to be re-associated, as described in 

.

Hardware reset

Proceed as follows:

Make sure the SpeedTouch™ is powered on.

Use a pen or an unfolded paperclip to push the recessed reset button on the 
back panel. The reset button is marked with a red circle. Keep it pushed until 
the power LED lights red - this will take about 7 seconds.  

Release the reset button.

The SpeedTouch™ restarts. 

Be aware that a reset to factory defaults will revoke all configurational 
changes you made to the SpeedTouch™.

Your system administrator may have disabled the physical reset button of 
the SpeedTouch™. In this case, a hardware reset to defaults is not possible.

ISDN