Canon LV-7585 Instruction Manual

Open the battery 

compartment lid.

Install new batteries into 

the compartment.

Replace the 

compartment lid.

Press the lid downward and 

slide it.

For correct polarity (+ and –), 

be sure battery terminals are 

in contact with pins in the 

compartment.

To insure safe operation, please observe the following precautions :
 

●

  Use two (2) AAA or LR03 type alkaline batteries.

 

●

  Always replace batteries in sets.

 

●

  Do not use a new battery with a used battery.

 

●

  Avoid contact with water or liquid.

 

●

  Do not expose the remote control unit to moisture or heat.

 

●

  Do not drop the remote control unit.

 

●

  If the battery has leaked on the remote control unit, carefully 

wipe the case clean and install new batteries.

 

●

  Risk of an explosion if battery is replaced by an incorrect type. 

 

●

  Dispose of used batteries according to the instructions.

Point the remote control unit toward the projector (to 

Infrared Remote Receivers) when pressing the buttons. 

Maximum operating range for the remote control unit is 

about 16.4’ (5 m) and 60 degrees in front and rear of the 

projector.

Infrared Remote Receivers are provided both in front and 

back of the projector. You can conveniently use both of 

the receivers (pp. 10, 51).

16.4’
(5 m)

The remote control unit can be used as a wired remote control unit. 

Wired remote control unit helps you use the remote control unit 

outside of the operating range (16.4’/ 5 m). Connect the remote 

control unit and the projector with the remote control cable (sold 

separately). Connected with the remote control cable, the remote 

control unit does not emit wireless signal.

16.4’
(5 m)