Sony PX35 User Manual

11

 GB

Location and Function of Controls

Over

v

iew

Although the lamp goes out, the 
cooling fan keeps running. The power 
saving mode is canceled when a signal 
is input or any key is pressed. In power 
saving mode, any key does not 
function for the first 60 seconds after 
the lamp goes out. 

• ON/STANDBY: Lights up or flashes 

under the following conditions:
– Lights in red when a AC power cord 

is plugged into a wall outlet. Once in 
standby mode, you can turn on the 
projector with the 

I

 / 1 key.

– Lights in green when the power is 

turned on.

– Flashes in green while the cooling 

fan runs after the power is turned off 
with the  

I

 / 1 key. The fan runs for 

about 90 seconds after the power is 
turned off.
The ON/STANDBY indicator 
flashes quickly for the first 60 
seconds. During this time, you 
cannot light up the ON/STANDBY 
indicator with the  

I

 / 1 key.

l

m

Connects to an optional security cable 
(Kensington’s).

Home page address: 
http://www.kensington.com/

n

o

p

q

• Do not place anything near the 

ventilation holes as it may cause 
internal heat build-up.

• Do not place your hand or objects near 

the ventilation holes as it may cause the 
air coming out heat build-up.

• To maintain optimal performance, clean 

Adjusts the height of the projector as 
follows:

Lift the projector and press the 
adjuster adjustment buttons.

The adjusters will extend from the 
projector.

While pressing the buttons, adjust the 
projector to the desired height, and 
then release the buttons. For fine 
adjustment, turn the adjusters to the 
right and the left.

• Be careful not to let the projector down on 

your fingers.

• Do not push hard on the top of the projector 

with the adjusters out.
It may be occurred malfunction.

Adjuster adjustment buttons

to lower 
the 
projector

to raise the 
projector