Epson EMP-1825 User Manual
Specifying the projector(s) that will respond to the remote control when multiple projectors are used
33
B
Choose the ID you want to set and press the [Enter]
button.
button.
C
Press the [Menu] button to close the configuration
menu.
menu.
Setting the ID of the projector to be operated
The ID of the projector to be operated must be set every time the projector
is powered on.
is powered on.
Point the remote control at the remote receiver of each of the set
projectors, and then perform the following steps for each.
projectors, and then perform the following steps for each.
While holding down the [ID] button, press the number
button corresponding to the ID of the projector to be
operated.
button corresponding to the ID of the projector to be
operated.
Once this setting has been made, only the specified projector(s) can be
operated with the remote control.
operated with the remote control.
Procedure
q
You can check which projector(s) can be operated with the
remote control as described below.
• Point the remote control at the remote receiver of the
remote control as described below.
• Point the remote control at the remote receiver of the
projector you want to check, and then press the [ID]
button. The following is displayed.
button. The following is displayed.
Keep
pressed
When remote control operations are
enabled: