JVC DLA-G150HTE User Manual

DLA-G150HTE

1-20

No.51847

■ Remote control unit

While projecting an image, a still picture is obtained at any 
time by using the FREEZE button on the remote control.

“FREEZE” appears on the screen for a few seconds and 
then the still picture is shown on the screen. Refer to the 
FREEZE message shown on the left of this page.

The original image resumes.

• During freezing, the picture sent from the signal source is 

lost.

• If any of the inoperative buttons (“MENU”, “QUICK ALIGN.”, 

“KEYSTONE”) are pressed while displaying a still picture, 
“FREEZE” is displayed on the screen.

• This function will not work with some signal sources 

(UXGA, etc). In this case, the FREEZE inhibit message 
appears for a few seconds, as shown on the left. To forcibly 
clear this message, press the EXIT button.

A part of the image being projected can be digitally magnified up 
to four times. When the DIGITAL ZOOM T or W button is 
pressed, “Digital zoom” appears on the screen together with the 
level bar and magnifying power (

×

1.0, 

×

1.2, 

×

1.4, 

×

1.6, 

×

2.0, 

×

2.5, 

×

3.2, 

×

4.0). When “15 sec.” is displayed in the menu, 

“Digital zoom” will appear in approximately 15 seconds.

• To zoom up or zoom down, press the DIGITAL ZOOM T or 

W button on the remote control.

While “Digital zoom” appears on the screen, you can move 
the zoomed image with the cursor (

5

/

∞

/

2

/

3

) button on the 

remote control.

5

: Upper part of the image will be

displayed.

∞

: Lower part of the image will be

displayed.

2

: Left side part of the image will

be displayed.

3

: Right side part of the image

will be displayed.

• This function will not work with some signal sources 

(UXGA, etc). In this case, the DIGITAL ZOOM inhibit 
message appears for a few seconds, as shown on the left. 
To forcibly clear this message, press the EXIT button.

• The quality of the zoomed image reduces in comparison 

with the original one.

• To return to the original size (

×

1.0) and original position, 

press the PRESET button while “Digital zoom” is displayed 
on the screen.

RM-M150 REMOTE CONTROL UNIT

FREEZE button

PRESET button

EXIT button

DIGITAL ZOOM

T/W button

Cursor buttons

5/∞ / 2/3

Digital zoom

1.2

■ Remote control unit

The Quick Alignment function automatically adjusts (sets) 
the screen settings of the image input from the PC1 or PC2 
input terminals. This can only be performed from the remote 
control.

While projecting an image on the screen, press the QUICK 
ALIGN. button on the remote control.
Quick alignment is conducted to obtain best image.

• This only works for the signals input from the PC1 or PC2 

input terminals. It does not work for the signals input from 
the AV IN terminal (VIDEO or Y/C input terminal).

• The quick alignment function is used to automatically adjust 

the “Brightness”, “Contrast”, “Horizontal and vertical 
position”, “Phase” and “Tracking” of the projected image.

• When using the quick alignment function to automatically 

adjust the image, use a bright, still-picture. It may not 
function correctly on a dark or motion picture. If the results 
obtained with the quick alignment function are not 
satisfactory, manually adjust the “Brightness”, “Contrast”, 
“Horizontal and vertical position”, “Phase” and “Tracking” of 
the projected image.

RM-M150 REMOTE CONTROL UNIT

QUICK ALIGN.

button

Q u i c k   A l i g n m e n t