Infocus 210 User Manual
5
SETTING UP THE PROJECTOR
1
Place the projector on a flat surface.
•
The projector must be within 10 feet of your power source
and within 10 feet of your computer.
and within 10 feet of your computer.
NOTE: An optional extension
cable, sold separately, lets you
increase the distance between the
projector and your computer to 50
•
If you want to project from behind a translucent screen, set
up the projector behind your screen. See “Rear Projection”
on page 40 to reverse the image.
up the projector behind your screen. See “Rear Projection”
on page 40 to reverse the image.
•
If you are installing the projector on the ceiling, refer to the
LitePro 200 Series Ceiling Mount Installation Guide for more
information. To turn the image upside down, see “Ceiling”
on page 39. The Ceiling Mount Kit is sold separately; see
page 58.
LitePro 200 Series Ceiling Mount Installation Guide for more
information. To turn the image upside down, see “Ceiling”
on page 39. The Ceiling Mount Kit is sold separately; see
page 58.
2
Position the projector the desired distance from the screen.
•
The distance from the lens of the projector to the screen
determines the size of the projected image. Figure 2 shows
three projected image sizes using the varifocal lens or the
zoom lens at minimum focusing distance. For more infor-
mation about image size, see “Projected Image Size” on
page 64.
determines the size of the projected image. Figure 2 shows
three projected image sizes using the varifocal lens or the
zoom lens at minimum focusing distance. For more infor-
mation about image size, see “Projected Image Size” on
page 64.
3
Make sure the projector and your computer are turned off.
F
IGURE
2
Projected image size (varifocal lens, zoom lens at minimum focusing distance)
4 ft
.
10 ft.
25 ft.