Boxlight CD-40m User Manual
32
M
a
i
n
t
e
n
a
n
c
e
&
T
r
o
u
b
l
e
s
h
o
o
t
i
n
g
8
Align the new lamp module in the correct direction.
9
Gently push the module in as far as it goes.
10
Tighten the screws on the outside of the module.
11
Slide the lamp connector to the left to re-attach it.
12
Insert the tabs at the top of the lamp door into the projector
and press the lamp door into place.
and press the lamp door into place.
13
Plug in the power cord and turn the projector back on.
14
To reset the lamp hour counter in the Status window, press
and hold the left mouse button, then press the menu button
(while still holding down the mouse button) for 5 seconds.
Verify that the counter was reset by pressing the menu button
and viewing the counter in the Status window.
and hold the left mouse button, then press the menu button
(while still holding down the mouse button) for 5 seconds.
Verify that the counter was reset by pressing the menu button
and viewing the counter in the Status window.
Using the Kensington Lock
The projector has a Kensington Security Standard connector for
use with a Kensington MicroSaver Security System (Figure 23).
Refer to the information that came with the Kensington System
for instructions on how to use it to secure the projector.
use with a Kensington MicroSaver Security System (Figure 23).
Refer to the information that came with the Kensington System
for instructions on how to use it to secure the projector.
F
IGURE
23
Installing the Kensington lock