Star Micronics 347F User Manual
– 7 –
2-2. SP347
1 Turn the power switch on the printer
to the off position.
2 To remove the front cover lift it up
approx. 3cm. and pull it forward.
NOTE: Do not touch the print head
NOTE: Do not touch the print head
immediately after printing
as it can be extremely hot.
as it can be extremely hot.
3 To remove the rear cover lift it up
approx. 3cm and push it backwards.
Fig. 2-5 Removing the rear cover (SP347)
4 Adjust DIP switch 2-4, the roll paper holder and the adjust lever position
according to the width and thickness of the roll paper that is being used.
•
Refer to Installation Manual in regard to the position of the DIP switch.
•
If you do not know the standard position of the adjust lever, lower the adjust
lever as far as it will go (on the rear cover side), and then pull it two positions.
That position is standard position A.
lever as far as it will go (on the rear cover side), and then pull it two positions.
That position is standard position A.
Paper
DIP switch 2-4
Adjust lever
Roll paper holder
Paper width Thickness
(Fig. 4-1)
position (Fig. 2-6)
(Fig. 2-7)
2.25 inches
1 sheet of paper
OFF
A
Used (Inner groove)
Printer paper
OFF
B
Used (Inner groove)
3.0 inches
1 sheet of paper
ON
A
Used (Outer groove)
Printer paper
ON
B
Used (Outer groove)
3.25 inches
1 sheet of paper
ON
A
Not used
Printer paper
ON
B
Not used
ENGLISH
Power off
Rear cover