Toshiba B-SA4TP User Manual
APPENDIX 2 INTERFACE
ENGLISH VERSION EO1-33048
APPENDIX 2 INTERFACE
EA2- 1
APPENDIX 2 INTERFACE
Parallel interface (Centronics)
Mode:
Conforming to IEEE1284
Compatible mode (SPP mode), Nibble mode
Compatible mode (SPP mode), Nibble mode
Data input method: 8 bit parallel
Control signal:
Control signal:
Data input code:
ASCII code
European 8 bit code
Graphic 8 bit code
JIS8 code
Shift JIS Kanji code
JIS Kanji code
European 8 bit code
Graphic 8 bit code
JIS8 code
Shift JIS Kanji code
JIS Kanji code
Receive buffer:
1M byte
SPP Mode
Nibble Mode
nStrobe HostClk
nAck PtrClk
Busy PtrBusy
Perror AckDataReq
Select Xflag
nAutoFd HostBusy
nInit nInit
nFault nDataAvail
nSelectIn IEEE1284Active
nAck PtrClk
Busy PtrBusy
Perror AckDataReq
Select Xflag
nAutoFd HostBusy
nInit nInit
nFault nDataAvail
nSelectIn IEEE1284Active
NOTE:
To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:
To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:
• In case of a parallel interface cable or serial interface cable, fully shielded and fitted with metal or metallised
connector housings.
• Keep as short as possible.
• Should not be bundled tightly with power cords.
• Should not be bundled tightly with power cords.
• Should not be tied to power line conduits.
• A parallel interface cable to be used should conform to IEEE1284.
• A parallel interface cable to be used should conform to IEEE1284.