Toshiba B-850 User Manual

APPENDIX 4 SYSTEM MODE

EO1-33029

A4.2 Overview

A4- 2

A4.2 Overview

System Mode consists of four main menus: Self-Diagnostic Test, Printer
Parameter Fine Adjustment, Test Print and PCL Emulation Setting.

While pressing the

[FEED]

and

[PAUSE]

keys at the same time, turn

onon the printer. Hold both keys until “<1>DIAG. Vx.x” message
appears on the display.

NOTE:

•

System Mode menus can be
selected with the

[RESTART]

[FEED]

key.

•

Pressing the

[PAUSE]

key

allows you to enter the sub
menus of each System Mode
menu. Flowcharts of each
menu’s sub menus are provided
on the following pages.

[FEED]

This is the start of the Self-
Diagnostic Test menu.

This is the start of the Printer
Parameter Fine Adjustment menu.

This is the start of the Test Print
menu.

This is the start of the PCL
Emulation menu.

[RESTART]

!',$*9[[

!$'-8676(7

!7(6735,17

!3&/(08/$7,21

IMPORTANT!

If the power is turn ON while

pressing and holding the

[FEED]

and

[PAUSE]

keys at

the same time, the printer will
enter the

System Mode

intended for Service
Personnel.

In addition to the menus shown
in the chart on the

right,

the

following menus are also
displayed in the System Mode
for Service Personnel:
<2>PARAMETER SET
<5>SENSOR ADJ.
<6>RAM CLEAR
<7>IP ADDRESS

Please do not change the
parameter settings for these
items, as doing so may cause
the printer to malfunction.

If you should accidentally
enter the System Mode for
Service Personnel, just turn
the power off. If you should
change the settings by
accident and the printer
malfunctions, please contact
your nearest TOSHIBA TEC
service representative.