Xerox 6120 User Manual

Read all caution and warning labels carefully, making sure to follow any 
instructions contained in them. These labels are located on the inside of the 
printer’s covers and the interior of the printer body.

Handle the printer with care to preserve its life. If dust and paper scraps 
remain on the inside or outside of the printer, printer performance and print 
quality will suffer, so the printer should be cleaned periodically. Keep the 
following guidelines in mind.

Turn off the printer, unplug the power cord, and disconnect all interface 
cables before cleaning. Do not spill water or detergent into the printer; 
otherwise the printer will be damaged and an electric shock may occur.

The fuser unit is hot. When the top cover is opened, the fuser unit 
temperature drops gradually (one hour wait time).

„

Be careful when cleaning the inside of the printer or removing media 
misfeeds, as the fuser unit and other internal parts may be very hot.

„

Do not place anything on top of the printer.

„

Use a soft cloth to clean the printer.

„

Never spray cleaning solutions directly on the printer’s surface; the spray 
could penetrate through the air vents of the printer and damage the 
internal circuits.

„

Avoid using abrasive or corrosive solutions or solutions that contain 
solvents (such as alcohol and benzene) to clean the printer.

„

Always test any cleaning solution (such as mild detergent) on a small 
inconspicuous area of your printer to check the solution’s performance.

„

Never use sharp or rough implements, such as wire or plastic 
cleaning pads.

„

Always close the printer’s covers gently. Never subject the printer 
to vibration.

„

Do not cover the printer immediately after using it. Turn it off and wait until 
it cools down.