Xerox 5222 User Manual

17

The machine is designed to use various paper types and other media. This chapter 
provides information on loading paper and other types of media into the machine.

The machine can be equipped with various paper trays. Depending on the machine 
configuration, up to six paper trays are available including the Envelope Tray. This 
section provides information on how to load paper into each type of tray.
NOTE: Make sure the side and rear paper guides on the trays are properly positioned 
to match the size of paper loaded. If there is a gap between the paper stack and the 
guides, paper may not be fed into the machine properly, or paper jams may occur.

For information on the paper sizes and media types for each tray, refer to 

For information on the acceptable range of paper sizes and capacity for each tray, refer 
to 

Before loading paper into the paper trays, fan the edges. This procedure separates any 
sheets of paper that are stuck together and reduces the possibility of paper jams.
NOTE: To avoid paper jams and misfeeds, do not remove paper from its packaging 
until required.

Trays 1 to 4 can be loaded with standard and non-standard sized paper.
NOTE: If the machine is processing a job, do not open the active paper tray.

Pull out the paper tray towards 
you.

NOTE: To avoid jams and misfeeds, 
do not load paper on top of any 
remaining paper in the tray. Remove 
the paper, and reload it on top of the 
new stock loaded.

If required, move the paper tray 
guides further out to load the 
new stock.
To adjust the side and rear 
guides, pinch the guide lever on 
each guide and slide the guides 
to their new position. To secure 
the guides in position, release 
the levers.