Xerox 5222 User Manual

12 Server Fax 

296

15)Select a protocol.
NOTE: When [FTP] or [SMB] is selected, faxes will be sent to the destination specified 
under [Fax Destination]. When [SMTP] is selected, faxes will be sent to the destination 
specified in the E-mail settings. 

• When [FTP] or [SMB] is selected

Set the server that is to be used for the Server Fax service. 
– IP Address/Host Name & Port (If the port number is blank or set to “0”, the default 

port number (FTP:21 or SMB:139) will be used.)

NOTE: The IP address must be in IPv4 format.

– Share (SMB only)
– Document path
– Login name
– Password
– Retype password

• When [SMTP] is selected

The SMTP server settings conform to the E-mail settings. For details on the SMTP 
server settings, refer to 

.

On the [Fax Repository Setup] screen, the following SMTP settings are required.
– Domain name (The IPv6 format is not supported.)
– E-mail address display format

16)Click [Apply] to reflect the settings.

To make sure that Server Fax has been set up correctly, perform the following steps:

Load a document.

Make sure that the Server Fax service is enabled.

Select [Fax] on the All Services screen.

Select the required features for the job.

Specify a destination.

Press the <Start> button.