Xerox 604P18057 User Manual

The Tandem Tray Module allows you to load larger amounts of paper. It consists of two 
trays.
NOTE: You cannot load custom size paper into the Tandem Tray Module.

Pull out the Tray 3 or Tray 4 of 
TTM.

The elevator in the tray lowers.

Place the paper stock tightly 
against the left rear corner of the 
tray.

NOTE: Do not load paper above the 
maximum fill line.

NOTE: Always load paper into the tray in the orientation shown in the diagram.

Close the tray.

The elevator rises and positions the paper for use.

The machine automatically switches from one tray to another under the following 
conditions.

• When printing and the active tray runs out of paper.

• When the paper size sensed differs from the previously determined size.

• When paper feeding starts and the selected tray is open.

• When paper feeding starts and the selected tray malfunctions.
NOTE: The bypass tray cannot be used with Auto Tray Switching.

NOTE: Key Operator access is required to set target trays and priorities. For more 
information, refer to Paper Tray Priority in the Setups chapter on page 196 and Paper 
Type Priority in the Setups chapter on page 196.

When not in use, the paper trays can be opened and paper can be loaded while the 
machine is running. However, do not open the active tray. This will cause the machine 
to stop the job being processed.

Always use high-quality, xerographic-grade paper in the machine. Damaged, curled, or 
damp paper can cause jams and image quality problems. Follow these simple rules to 
store paper.