Edimax Technology PS-1201 User Manual

server should be located on the same subnet as the 

PrintSir. If you use Network Information Services (NIS) 

in your system, you may need to rebuild the NIS map 

with the BOOTP services before doing the following 

BOOTP configuration. To rebuild the NIS map, please 

refer to your system documentation. 

To configure the IP address data for the BOOTP 

server, you will need to log in the host of BOOTP 

server as the super user (root). Perform the following 

steps to add address entries, 

1.  Optionally, assign a name corresponding to the 

PrintSir’s IP address.  You can add this address 

to the /etc/hosts file, by adding a line such as: 

2.  Add an entry to the host’s /etc/bootptab file, 

similar to the following: 

Lines should be indented with tabs. 

Where hostname is the device name of a PrintSir, 

the  ht=1 tag specifies the hardware type is Ethernet, 

the ha= tag specifies the Ethernet address of a PrintSir, 

which is the Node ID located on the PrintSir. The ha 

tag must be preceded by the ht tag. The ip= tag should