Yamaha VL70-m User Manual
21
Setting Up
Connecting to an NEC PC-9801/9821 Series Computer
The NEC PC-9801/9821 computers are widely used in Japan. Connect the TO
HOST connector of the VL70-m to the RS-232C port on your NEC computer,
using a standard 8-pin MINI DIN
HOST connector of the VL70-m to the RS-232C port on your NEC computer,
using a standard 8-pin MINI DIN
→
25-pin D-SUB cross cable. Set the TO
HOST selector to the “PC-1” position.
Refer to your software owner’s manual for information on any settings you
might have to make on the computer side.
Refer to your software owner’s manual for information on any settings you
might have to make on the computer side.
■ NOTES
• If your system doesn’t work properly with the connections and settings listed above,
• If your system doesn’t work properly with the connections and settings listed above,
your software may require different settings. Check your software operation manual and
set the HOST SELECT switch to the position the provides the appropriate data transfer
rate.
set the HOST SELECT switch to the position the provides the appropriate data transfer
rate.
● “PC-1” Cable Connections
• 8-pin mini DIN
→
25-pin D-SUB cable. Use a “PC-2” type cable if
your computer uses a 9-pin serial port.
• Data transfer rate: 31,250 bps.
mini Din 8-pin
D-SUB 25-pin
Connecting to an IBM PC/AT Series Computer
Connect the TO HOST connector of the VL70-m to the RS-232C port on your
IBM computer, using a standard 8-pin MINI DIN
IBM computer, using a standard 8-pin MINI DIN
→
9-pin D-SUB cross cable.
Set the TO HOST selector to the “PC-2” position.
Refer to your software owner’s manual for information on any settings you
might have to make on the computer side.
Refer to your software owner’s manual for information on any settings you
might have to make on the computer side.
● “PC-2” Cable Connections
• 8-pin mini DIN
→
9-pin D-SUB cable. Use a “PC-1” type cable if
your computer uses a 25-pin serial port.
• Data transfer rate: 38,400 bps.
mini Din 8-pin
D-SUB 9-pin