Primera Technology LX400 User Manual

Output Mode

Do not present (use with Rewinder). The label stock does not

move after the last label is printed.  This means that part of the

last label printed is still in the printer.  This should be used

only if you have a label rewinder attached.
Present (Default). This setting will cause the printer to feed the

last label printed forward so that it and the previously printed

labels can be torn off using the tear bar.  This will occur only if

there are no other print jobs in queue.
Cut (using optional cutter). Use this setting only if you have

the label cutter attachment (Primera Part # 074263)

Enable Bi-di Printing

This setting defaults to Yes for fastest printing.  When enabled

you will be required to perform an alignment print after a new

cartridge is installed.  

Offsets

If your label is printing horizontally or vertically offset 

(printing on the liner or with white space left on the label) use

these offset setting to adjust the position of the print on the

label.  Click Offsets... to reveal the properties button.  Click

Properties.  The following screen will appear. Refer to the 

diagram to determine which direction to move the image, 

tear off position or cut position. 

510984.qxd  11/21/2006  9:08 AM  Page 30