Primera Technology LX400 User Manual

Left Margin Offset

This will be factory calibrated. If fine tuning is needed, increase

this setting to move the image right on the label; decrease this

setting to move the image to the left on the label. The unit of

measure is 0.1mm.

Top of Form (TOF)

This setting allows you to fine tune the print starting position

on your label stock.  This will be factory calibrated.  If fine tun-

ing is needed, increase this value to move the image down on

the label. Decrease this value to move the image up the label.

The unit of measure is 0.1mm.
Click the Test button to send a

test print to the printer that

will help you adjust the TOF

and Left Margin Offset.  The

printer will print the pattern

shown.  Adjust the values so

that both black bars print on

the label with no white space

on the label and no ink on the

liner.

Tear Off Position

If Output Mode (described earlier in this section) is set to

Present, the printer will present your labels over the Tear Bar

for easy removal.  This tear off position is set at the factory.  

If fine tuning is needed to align the break in your label stock

over the Tear Bar, increase this setting to eject the label further;

decrease this setting to eject the label stock less.  The unit of

measure is 0.1 mm.

Cut Position

If a label cutter attachment is connected to the printer you can

fine tune the cut position between the labels. Increase this

value to move the label further out before the cut; decrease 

this value to eject the label stock less before the cut.

+

+

-

-

LEFT OFFSET

TOF

(10 units)

1.0 mm

510984.qxd  11/21/2006  9:08 AM  Page 31