Ricoh AP2610 User Manual
Installing Options
22
2
EEEE
Pull out the handle of the control-
ler board.
ler board.
FFFF
Pull the handle and slide the con-
troller board out.
troller board out.
GGGG
Place the controller board on a flat
surface.
surface.
HHHH
Use a coin to remove the two
screws, and then remove the cover.
screws, and then remove the cover.
Note
❒ These screws are used again in
step
.
❒ The removed cover is not used
when installing the Network In-
terface Board.
terface Board.
IIII
Insert the end of the Network In-
terface Board into the opening
(
terface Board into the opening
(
A
A
A
A), and then push down until it
clicks (
B
B
B
B).
JJJJ
Fasten the Network Interface
Board to the controller board.
Board to the controller board.
ZGDX370J
ZGDX261J
ZGDX410J
ZGDX422J
ZGDX432J
ZGDX441J