Ricoh AP2610 User Manual
Network Interface Board Type 2610
23
2
KKKK
Match the controller board to the
top and bottom rail using the "
top and bottom rail using the "
T
T
T
T"
mark, and then slide it into the
printer slowly until it stops.
printer slowly until it stops.
LLLL
Push back the handle of the con-
troller board until it clicks.
troller board until it clicks.
MMMM
Fasten the controller board to the
printer with the two screws.
printer with the two screws.
Note
❒ If the Duplex Unit is not at-
.
NNNN
While aligning the power cord to
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
OOOO
Plug the printer's power cord
back into the wall outlet, and then
turn on the power switch.
back into the wall outlet, and then
turn on the power switch.
ZGDX253J
ZGDX380J
ZGDX271J
ZGDX241J