OKI C3520 User Manual
Operation > 60
Image Quality: Select from Mixed, Photo, HiRes. Mixed,
HiRes. Photo.
HiRes. Photo.
Density: Sets scan density - -3, -2, -1, 0, +1, +2, +3
Input tray: Select which paper tray you are using,
Tray 1, Manual Feeder.
Tray 1, Manual Feeder.
Collate: Select from ON, OFF
N-up: Sets the number of images on a page.
Select from: 1in1, 2in1, 4in1 (horizontal), 4in1 (vertical).
Edge erase: This sets the peripheral areas of the
document to block out.
document to block out.
Select from: 0.00 in, 0.25 in, 0.50 in, 0.75 in, 1.00 in
or
0 mm, 6 mm, 13 mm, 19 mm, 25 mm
NOTE:
N-up can only be changed from 1in1 if paper size is set to A4
or Letter and documents are scanned from the ADF. Collate
always defaults to “OFF”, Reduce/enlarge to “100%”, Edge
erase to “0mm (0.001in)” and Margin shift-Right/Bottom to 0
mm (0.00in).
N-up can only be changed from 1in1 if paper size is set to A4
or Letter and documents are scanned from the ADF. Collate
always defaults to “OFF”, Reduce/enlarge to “100%”, Edge
erase to “0mm (0.001in)” and Margin shift-Right/Bottom to 0
mm (0.00in).
NOTE:
The setting displayed, mm or inch, depends on the setting in
Admin Setup - System Setup - Unit of Measure in Menu Mode.
If Edge Erase is set to other than "0 mm" or "0.00 in,"
Reduce/Enlarge always defaults to "100%," N-up to "1in1,"
and Margin Shift-Right/Bottom to "0 mm (0.00 in)".
The setting displayed, mm or inch, depends on the setting in
Admin Setup - System Setup - Unit of Measure in Menu Mode.
If Edge Erase is set to other than "0 mm" or "0.00 in,"
Reduce/Enlarge always defaults to "100%," N-up to "1in1,"
and Margin Shift-Right/Bottom to "0 mm (0.00 in)".