OKI C3520 User Manual
Operation > 61
Margin shift - right: This sets the amount to shift the
document image to the right.
document image to the right.
Select from: 0.00 in, 0.25 in, 0.50 in, 0.75 in, 1.00 in
or
0 mm, 6 mm, 13 mm, 19 mm, 25 mm
Margin shift - bottom: This sets the amount to shift the
document up.
document up.
Select from: 0.00 in, 0.25 in, 0.50 in, 0.75 in, 1.00 in
or
0 mm, 6 mm, 13 mm, 19 mm, 25 mm
4.
Press the Left arrow key to return to the start menu.
NOTE:
Any parts of the image that do not fit on the paper as a result
of this setting, are not printed. The setting displayed, mm or
inch, depends on the setting in Admin Setup - System Setup
- Unit of Measure in Menu Mode. If Margin Shift-Right is set
to other than "0 mm" or "0.00 in," Edge Erase always defaults
to "0mm (0.00in)" and Reduce/Enlarge can be set only to less
than 100%.
Any parts of the image that do not fit on the paper as a result
of this setting, are not printed. The setting displayed, mm or
inch, depends on the setting in Admin Setup - System Setup
- Unit of Measure in Menu Mode. If Margin Shift-Right is set
to other than "0 mm" or "0.00 in," Edge Erase always defaults
to "0mm (0.00in)" and Reduce/Enlarge can be set only to less
than 100%.
NOTE:
Any parts of the image that do not fit on the paper as a result
are printed. The setting displayed, mm or inch, depends on
the setting in Admin Setup - System Setup - Unit of Measure
in Menu Mode.
Any parts of the image that do not fit on the paper as a result
are printed. The setting displayed, mm or inch, depends on
the setting in Admin Setup - System Setup - Unit of Measure
in Menu Mode.
If Margin Shift-Right is set to other than "0 mm" or "0.00 in,"
Edge Erase always defaults to "0mm (0.00in)" and Reduce/
Enlarge can be set only to less than 100%.
Edge Erase always defaults to "0mm (0.00in)" and Reduce/
Enlarge can be set only to less than 100%.