Gateway ALR 7200 User Manual

6     Gateway ALR 7200 User’s Guide

Press the On/Off switch on the front panel, and the green LED on the front 
panel will illuminate ON.

If you turn off your system, you must wait at least ten seconds before you 
turn the system back on.

The system self-checks the memory even if the monitor is not connected. If 
the monitor is connected and powered ON, the screen displays the power-up 
sequence. 

•

If more than one CPU is installed, the system displays which CPU 
it is currently testing.

•

If any errors are encountered, your system displays them on the 
monitor.

•

If a monitor is not connected or the system is unable to display an 
error, an error beep code sounds.

•

If the system encounters an error, it is most likely a nonfatal one, 
meaning the system will function until the error can be corrected 
(usually through the BIOS Setup).

Quick Check

If your system does not operate correctly, re-read the instructions for the 
procedure(s) you have performed. If an error occurs within an application, 
consult the documentation supplied with the software.

This section identifies solutions to common problems. If the suggestions in 
this section are not helpful, try looking up the problem in the 

. In the event of a problem, the following checks 

should be performed:

 Warning!

The bezel door must be 
closed and locked while the 
system is running.

 Note:

Under no circumstances 
return any equipment 
without obtaining a Return 
Material Authorization 
(RMA) number.

3435.boo  Page 6  Thursday, August 6, 1998  7:12 AM