Gateway 9210 User Manual
72
www.gateway.com
BIOS
The settings in the BIOS Setup utility are not retained
■
Replace the CMOS battery. For instructions, see
CD drive
Your server does not recognize a CD or the CD drive
■
Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Make sure that the IDE controllers are enabled. For more
information, see
your server restarts. Make sure that the IDE controllers are enabled. For more
information, see
■
Reinstall the device driver. For instructions, see
■
Turn off your server, then make sure the drive cables are connected correctly. For
instructions, see
instructions, see
Your CD drive tray does not open
■
Press a straightened paper clip wire into the CD drive’s manual eject hole. The drive
tray opens.
tray opens.
■
If this problem happens frequently while the server is turned on, the drive may be
defective.
defective.
Diskette drive
The diskette drive is not recognized
■
Restart your server.
■
Turn off your server, then make sure that the drive cables are connected correctly.
For instructions, see
For instructions, see
The diskette drive LED is lit continuously
■
Remove the diskette from the drive. If the light stays on, try restarting your server.
■
Turn off your server, then remove the combination drive and push it in again to make
sure the drive is seated correctly. For instructions, see
sure the drive is seated correctly. For instructions, see