Gateway 9210 User Manual
73
www.gateway.com
Expansion cards
Your server does not recognize an expansion card
■
Restart your server.
■
Make sure that you have installed the necessary software or driver. For instructions,
see the card’s documentation.
see the card’s documentation.
■
Reseat the expansion card. For instructions, see
Hard drive
The hard drive cannot be accessed, or you receive a “General failure reading drive C”
error message
error message
■
If a diskette is in the diskette drive, eject it and restart your server by pressing the
reset button.
reset button.
■
Restart your server by pressing the reset button.
■
Turn off your server, then make sure the drive cables are connected correctly. For
instructions, see
instructions, see
■
Run a verification from the SCSI BIOS. This applies only if your configuration includes
a SCSI hard drive.
a SCSI hard drive.
■
If your server has been subjected to static electricity or physical shock, you may need
to reinstall the operating system.
to reinstall the operating system.
You receive a “Non-system disk” or “disk error” error message
■
Eject the diskette from the diskette drive, then press E
NTER
.
■
Make sure that your hard drive has an active partition. For more information, see
Your server does not recognize an SCSI drive (applies to SCSI configured servers only)
■
Make sure that the SCSI controller is enabled in the BIOS Setup utility.
■
Reinstall the device driver. For instructions, see
■
Change the drive’s SCSI address to one that is not being used by your server. For more
information about SCSI device configurations, see your drive’s documentation.
information about SCSI device configurations, see your drive’s documentation.
■
Run SCSI Verify in the SCSI BIOS. For more information about the SCSI BIOS, see the
SCSI controller’s documentation.
SCSI controller’s documentation.
■
Turn off your server, then make sure the drive cables are connected correctly. For
instructions, see
instructions, see