Panasonic A4P Series User Manual

80

Display LED (6-digit)
All of LED will flash when error occurs, and switch to error display 
screen. 

Display LED (in 2 digits) 
Parameter No. is displayed at parameter setup mode. Point No. is 
displayed at teaching mode.

SHIFT Button  
Press this to shift the digit for data change.

            Button  
Press these to change data or execute selected action of parameter.
Numerical value increases by pressing ,      ,
decreases by pressing      .

SET Button
Press this to shift each mode which is selected by mode switching 
button to EXECUTION display.

Mode Switching Button    Press this to switch 7 kinds of mode.
  1)  Monitor mode
  2)  Teaching mode
       • Target position settings established 
         by teaching
       • Test operation
  3)  Parameter setup mode
  4)  EEPROM write mode

5)  Normal auto-gain tuning mode
6)  Auxiliary function mode
       • Alarm clear
       • Absolute encoder clear
7)  Copy mode
       • Copying of parameters from the driver to the console. 
       • Copying of parameters from the console to the driver.

• Release of RS232 communication error
   When RS232 communication error occurs as the Fig, below shows, 
   release it by pressing        and        at the same time.

1 sec

[flashes for approx. 0.6 sec each for initialization of the console]

Displays version No. of micro computer of the console. 
(Displayed figures vary depending on the version)

Initial display of LED
(Determined by the setup of SV.Pr01, "Initial Status of LED".)

0.6 sec

0.6 sec

0.6 sec

Turn on the power of the driver while inserting the console connector to the driver main body, or inserting the
console connector to CN X4 connector.