Powerware Model V-2000B User Manual

Maintenance = 103 

 

The Gigabit Server Adapter card has the following indicator lights: 

Green on 

The port is connected to a valid link 

partner 

Green flashing 

Data activity 

ACT/LNK 

(Left) 

 

Off 

No link 

Off 

10 Mbps 

Yellow flashing 

100 Mbps 

10=OFF 

100=YELLOW 

1000=GREEN 

(Right) 

Green 

1000 Mbps 

 

 

Be certain to shut down the Image Server, turn off the rear panel power 

switch and disconnect the power cord before opening the unit for service. 

 
The following sections provide instruction on disassembly and re-assembly for maintenance. 
The front panel is removed to access the internal CD-ROM drive (for system program updates), or 

to service the hard drives. 
The top cover is removed to access the analog/digital audio selection jumpers, or to service an I/O 

card, the system board, or power supply. 

The front panel is easily removed for access to the CD-ROM drive, the four disk drives, or for 

removing the server from an equipment rack.  Using a coin or a flat-blade screwdriver, unscrew 
the two large panel fasteners on the left and right sides of the face panel.  Hold the panel in 

place while undoing the screws.  Since the loosened screws are captive, you may use them to 

pull the panel away from the chassis. 
To re-install the front panel, tuck all wires into the chassis and move the face panel into 

position.  Screw the front panel fasteners back into the chassis.  Tighten the front panel access 

screws with a screwdriver. 

Using a No. 2 Philips head screwdriver, unscrew the three 6-32 Philips head screws attaching 

the top cover to the rear panel.  Slide the cover back until it is clear of the front panel, and then 

lift it off.