Cannon 3035 User Manual

Setting Up a Computer for Printing/Sending a Fax

Usin

g a 

TCP/IP Netw

or

k

IMPORTANT

 

If you use LPD, enter one of the following in [LPR Queue Name] in the [Add Port] 
dialog box of Canon LPR2: 

- LP

The machine prints according to its spool settings. Normally enter <LP> as a print 
queue.

- SPOOL

The machine prints only after spooling a print job on the hard disk, regardless of 
its spool settings.

- DIRECT

The machine prints without spooling a print job on the hard disk, regardless of its 
spool settings.

The procedure below uses screens of Windows 2000 as an example.

■ Installing a New Driver

Install the driver according to the following procedures indicated in the manual 
for each driver:

•

If you want to use the PCL printer driver 
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the 

PCL Driver Guide

.

•

If you want to use the PS printer driver 
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the 

PS Driver Guide

.

•

If you want to use the UFR II printer driver 
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the 

UFR II Driver Guide

.

•

If you want to use the fax driver
See the procedure for dynamic installation in Chapter 2, "Getting Started," in the 

Fax Driver Guide

.

NOTE

 

•

The print application will be LPD and the print queue will be set to <LP> if the driver 
has been installed according to the above procedures.

•

This machine enables you to specify print queues other than <LP>. You can also 
use Raw as the print application. For instructions on how to change the settings, 
see "Changing the Port after Installing the Driver," on p. 3-35.