Panasonic PT-DW10000E User Manual

Information

ENGLISH –

111

Procedure of lamp unit replacement

1. Be sure to observe the procedure “Powering up the projector” (p. 5)

and “Powering off the projector” (p. 6), remove the power plug and

confirm that the surroundings of the lamp unit have cooled off.

. Use a Phillips screwdriver to

loosen the lamp unit cover screw

at the rear of the projector until the

screw turns freely.

. Open the lamp unit cover and

remove it from the projector.

4. Use a Phillips screwdriver to

loosen the three fixing screws for

the lamp unit to be replaced until

the screws turn freely. Hold the

handle of the lamp unit and gently

pull the lamp unit out from the

projector.

5. Install the new lamp unit.
6. Use a Phillips screwdriver to securely tighten the lamp unit fixing

screws for each lamp unit.

7. Install and close the lamp unit

cover, and then use a Phillips

screwdriver to securely tighten the

lamp unit cover screw.

Caution

Firmly install the lamp unit and lamp unit cover. If not

installed firmly, a protection circuit will function and the

power will not be turned on.

•

CAUTION

The lamp unit and structural parts around the

lamp unit will be hot immediately after the

projector has been used.

You might get burned if you touch it while it is still

hot.

CAUTION

The lamp unit and structural parts around the

lamp unit will be hot immediately after the

projector has been used.

You might get burned if you touch it while it is still

hot.

Lamp unit cover screw

Lamp unit cover

Lamp unit cover screw

Lamp unit cover

Lamp unit 1

Lamp unit 4

Lamp unit 2

Lamp unit 3

Fixing

screws

Handle