Panasonic PT-D6000 User Manual

The projector has an ID number setting function that helps the 
user to control multiple projectors either simultaneously or 
separately with a single remote control. Press I H to cycle 
through the options.

When installing the projector, select the projection method 
according to the projector position. Press I H to cycle through 
the options.

If you use the projector at high elevation, the HIGH ALTITUDE 
MODE setting needs to be ON to set the fan speed high. Press 
I H to select the required option.

You can control the fan speed for projecting angle. Press I H 
to cycle through the options.

Available to control from any ID 
numbered remote control or computer.

Available to control from the same ID 
numbered remote control.

• See “Remote control ID” in the operating instructions booklet 

that is provided with the projector.

Setting on a desk/floor and projecting 
from front

Mounting on the ceiling and projecting 
from front

Setting on a desk/floor and projecting 
from rear

Mounting on the ceiling and projecting 
from rear

• See “Projection method” in the operating instructions booklet 

that is provided with the projector.

 

 

The fan speed is low.

The fan speed is high.

• At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the setting must 

be ON.

• The loudness of fan noise depends on the HIGH ALTITUDE 

MODE setting.

• When the projector is angled, COOLING CONDITION setting 

must be set correctly. Failure to observe this may result in 
malfunctions, or the life of the lamp or the other components 
may be shortened.