Panasonic PT-DS8500E User Manual

See “Navigating through the menu”  

 

z

See “MAIN MENU” and “SUB MENU”  

 

z

The projector has an ID number setting function that 

helps the user to control two or more projectors either 

simultaneously or separately with a single remote 

control.

The setting will change as follows each time 

 

z

◄► is pressed.

The ID number can be set to [ALL], or selected from [1] 

 

z

to [64].

If the projectors are given ID numbers, their remote 

 

z

controls must be assigned the same ID numbers, 

respectively.

If the ID number of a projector is set to [ALL], it can be 

 

z

controlled by the remote control or the PC with any ID 

number.

If multiple projectors are used and some of them 

have their IDs set to “ALL”, they cannot be controlled 

separately from the projectors with other ID numbers. 

A projection scheme can be chosen depending on 

the installation of the projector. If the picture is shown 

upside down or in reverse, change the projection 

scheme.

Select the setting by displaying the on-screen 

 

z

indications using buttons of the remote control or 

the control panel on the main unit.

The setting will change as follows each time 

 

z

◄► is pressed.

Setting on a desk/floor and 

projecting from front

Mounting on the ceiling and 

projecting from front

Setting on a desk/floor and 

projecting from rear

Mounting on the ceiling and 

projecting from rear

If you use the projector at high elevation (1 400 m to 

2 700 m), the [HIGH ALTITUDE MODE] setting needs 

to be [ON] to set the fan speed high.

The setting will change as follows each time 

 

z

◄► is pressed.

Select this when using in normal 

environment (less than 1 400 m 

above sea level)

Select this when using at high 

altitude (above 1 400 m and less 

than 2 700 m above sea level)

The loudness of fan noise depends on the [HIGH 

 

z

ALTITUDE MODE] setting.

The separately-sold Smoke Cut Filter cannot be used 

 

z

when the [HIGH ALTITUDE MODE] is [ON].