Panasonic D6KE User Manual

 Setting projector ID number to 

Each projector can be assigned a unique 2 digits ID 
number, and the remote control 2 digits ID number must 
be set to match the intended projector. The default 
setting of the projector ID is ALL. Set the ID of the 
projector in advance from the menu items.

1.Press the ID SET button.



Displays the projector ID number on the screen.

2.Within 5 seconds, enter the same number of the required 

projector by pressing the numeric buttons.



ID number range: 01 - 64

 Using a wired remote control

When multiple projectors are connected as part of the 
system, connect to units with a M3 stereo mini jack 
commercial cable to simultaneously control multiple main 
units with a single remote control through the REMOTE 1 
IN/OUT

 terminal. It is effective to use the wired remote 

control in the environment in which an obstacle stands in 
the light path or where devices are susceptible to outside 
light.

• Do not press the ID SET button accidentally or carelessly 

because the ID number on the remote control can be set even 
when no projector is around.

• If you do not enter the 2 digits ID number within 5 seconds 

after the ID SET button has been pressed, the ID will remain at 
the number that was set before the ID SET button was 
pressed.

• Your specified ID will be erased if the batteries of the remote 

control are left exhausted. When the batteries are replaced, 
set the same ID number again.

• Use 2 core shielded cable of length of 15 m or less. If the 

length of the cable exceeds 15 m (49'2"), the shielding of the 
cable may not be sufficient and the remote control may not 
work.

Connect to another 
projector

M3 stereo mini jack 
(commercial)

Connect to the remote 
control wired terminal